Characteristics of the blasting wall system

Application areas for venting wall panels:

Explosion wall system, motor room/cable fireproof coating, fireproof shaft, fireproof ceiling, glass fireproof skirt wall, steel structure fireproof coating, fireproof ceiling, fire ventilation duct, fire exhaust duct, fireproof plugging and sealing firewall, Explosion pressure relief external wall system, inner venting pressure relief plate, venting pressure relief keel, cavity filling insulation material, external venting pressure relief plate, double layer staggered arrangement, cavity filling insulation material

Explosion wall system features

Rapid release

The venting plate belongs to a lightweight brittle material, which is vented in a very short time in the event of an explosion, effectively reducing the superposition effect of the explosive force, and providing protection for personal and property safety.

2. It is not easy to form secondary damage when venting

The venting plate is in the form of a block and a powder when it is released from pressure. It has no sharp edges and corners, is light in weight, has low density, and the heat insulating layer is a light material. It is not easy to form secondary damage when the pressure is released.

3. Good strength

In the design of the project plan, the external wall wind pressure requirements and wall height factors will be fully considered to arrange the sand bar, keel and venting plate to ensure the stability of the wall while achieving the pressure relief function.

4. Lightweight

The total weight of the paint on the venting wall and the exterior finish is no more than 50Kg/m3, which is very beneficial to the load and vibration resistance of the entire building.

5. Durable

The venting plate has good weather resistance and can be used for 50 years under normal use conditions.

6. Excellent fire performance

The fireproof limit of the venting wall can be up to 4 hours depending on the fire rating of the building.

7. outstanding thermal insulation performance

The middle part of the blasting wall system is filled with insulation material for the cavity, which can meet the heat preservation requirements of conventional projects. If there is higher insulation requirement, the thickness of the wall can be adjusted by calculation, or can be realized according to the traditional external wall internal insulation and external insulation.

8. Anti-leakage process mature

As a mature external wall system, the venting and pressure relief system is processed by the staggered arrangement of the plates and the special caulking putty caulking. After the exterior wall coating is applied on the surface, the outer wall can be ensured without leakage.

9. Quick installation

The materials used for the venting and pressure relief roof are all formed by the factory. The site only needs to be welded and bolted. The density of the plate is low, which is convenient for opening and closing the line. The system installation is simple and quick.

10. Easy surface decoration

The surface of the venting wall is very flat, and there is no need to level the layer during the construction of the exterior wall paint, and it can directly enter the exterior wall coating process.