1. Do not pour petrol into the carburetor port while the engine is running or when it is cranking. The carburetor is filled with gasoline to increase the concentration of the air-fuel mixture in the cylinder. Although this will be beneficial if the oil fails to enter the cylinder, it is of no avail to the other causes of the failure, and this may also cause Burns, burns, and burned seal garbage trucks. 2. Maintenance of gasoline filter filter cores is not recommended when maintaining sealed garbage truck fuel filters. Many people like to use gas-fired ceramic filters to remove impurities from filter elements when they are maintaining sealed garbage filters. The hazard of doing so is easy to misfire, at the same time have an impact on the life of the filter element.
5, do not often use the method of hanging fire. Sometimes the sealed garbage truck spark plug will have carbon deposition. When the cylinder's carbon deposition is serious, the cylinder can't work normally. In order to make the cylinder run normally, the method of using the cylinder outside the "hanging fire" method (the spark plug and the high voltage wire A gap of 3 mm to 4 mm is left to improve the energy of the spark plug electrode flashover to make the cylinder work again. However, the ordinary “hanging fire†method is easy to fall off with little attention. If there is dripping gasoline on the cylinder, it is extremely easy to have a fire. Therefore it is only a temporary remedy. The correct treatment should be timely cleaning and maintenance of spark plugs, try to avoid the use of "hanging fire" method.
The above information is shared with you by Aoli sweeping car network! More sweeping vehicles, compressed garbage truck prices welcome to see the station.
4. Under the high voltage wires, fueling is prohibited.
The exceptionally cold winter temperatures in winter, coupled with the increase in the number of working days near the Spring Festival, compress garbage trucks need to be properly operated and maintained in order to allow them to work normally at lower temperatures.
6. Check if there is any leakage in the sealed garbage truck oil system. If the chassis part of the oil circuit is leaking, and it is on the ignition late, mixed gas lean point, due to slow combustion will lead to exhaust pipe fire, the body temperature increased, more than ten times the ignition point of gasoline vapor (gasoline vapor The ignition point is 28°C). Leaking out the oil can easily cause fire, resulting in scrapped garbage truck body scrap. If the carburetor part leaks on the cylinder head, the high-pressure spark leakage of the sealed garbage truck spark plug may also cause fire.
Mining Magnetic Separator Flotation Equipment
Mining Magnetic Separator & Flotation Equipment for EPC experiment lab testing machine processing equipment for sale
Mining Equipment Manufacturers Series Rcdd Conveyor Overband Magnetic Separator
Laboratory Magnetic Separator Mining Machinery Iron Ore Magnetic Roller Separator
Coltan Ore Processing Gold Mining Drum Separator High Intensity Wet Magnetic Separator
Metal Ore Mining Machine Magnetic Separator for Africa,East-south Asia countries
Gold Mining Equipment of Flotation Separation Machine with Factory Price
Complete Flotation Line Copper Mining Equipment EPC solution mining for Africa,Romania,Spanish,Chile,Mexico sale provider
Flotation Tank Copper Mining Equipment for Antimony
Mining Flotation Cell Equipment for Lead Zinc Ore Processing solution maker,EPC solution provider for Africa,Philippines
Flotation Machine can be used to separate nonferrous metal, ferrous metal, heavy metal, nonmetallic mine, chemical material such as gold, copper and recycling minerals. Each chute can inhale gas, sink magma, separate. No assisting equipment are required,and Flotation Machine must be levelly installed. Flotation Machine is easy to change the flow chart. The cycling way of magma is very reasonable. Flotation Machine can reduce the impurities to a great extent. There is automatic equipment on the magma surface, easy to adjust. The impeller also owns the upper and lower retroversion blade. The upper one makes the magma cycle upward, while the lower one makes the magma cycle downward.
Working principle of Flotation machine
The impellers are driven through V belt transmission, which brings centrifugal effect to form the negative pressure. On the one hand, the flotation machine inhales sufficient air to mix with ore slurry; on the other hand it stirs ore slurry and mix with medication to form the mineralized froth. To adjust the height of flashboard to control the liquid level and make the useful froth scraped by loam board. Each chute can inhale gas, sink magma, separate. No assisting equipments are required, and it must be levelly installed. It is easy to change the flow chart. The cycling way of magma is very reasonable. It can reduce the impurities to a great extent. There is automatic equipment on the magma surface, easy to adjust. The impeller also owns the upper and lower retroversion blade. The upper one makes the magma cycle upward, while the lower one makes the magma cycle downward.
Flotation Machine features:
1. Large inhaling capacity and low energy consumption;
2. Complete flotation circuit with inhaling air and pulp, no auxiliaries are needed;
3. Process is easy to be changed;
4. Reasonable circulation of pulp decreases coarse sand sedimentation;
5. Automatic controlling device makes adjustment more convenient.
Flotation Machine,Flotation Equipment,Froth Flotation Machine,Mining Magnetic Separator
Henan YikYui Prospecting Machinery Co., Ltd , https://www.yikyui-rig.com